Types of Water Damages

10/16/2019 (Permalink)

THERE ARE 3 BASIC CATEGORIES OF WATER Category 1: Clean water originates from a sanitary source such as a broken pipe, or other water source; rainwater is also considered clean and poses no substantial risk from dermal, ingestion, or inhalation exposure. However, it may not always remain clean after it meets other surfaces or materials. Category 2: Gray water is used to classify slightly contaminated water and has the potential to cause discomfort or sickness if contacted or consumed by humans. It may contain potentially unsafe levels of microorganisms or nutrients for microorganisms, as well as other organic or inorganic matter (chemical or biological). Category 3: Black water is highly contaminated and filled with pathogenic, toxigenic or other harmful agents. Such water sources may carry silt, organic matter, pesticides, heavy metals, regulated materials, or toxic organic substances. Black water is typically caused by sewage damage, flooding or any type of natural disaster; Black water should always be handled by trained professionals.

THE 4 PRIMARY CLASSIFICATIONS OF WATER DAMAGE

• Class 1 is the least amount of water, absorption and evaporation. It affects only part of a room or area, or larger areas containing materials that have absorbed minimal moisture. Little or no wet carpet and/or cushion is present.
• Class 2 involves a large amount of water, absorption and evaporation. It affects at least an entire room of carpet and cushion (pad). Water has wicked up walls less than 24 inches. There is moisture remaining in structural materials and substructure soil.
• Class 3 involves the greatest amount of water, absorption and evaporation. Water may have come from overhead.  Ceilings, walls, insulation, carpet, cushions and subfloor in virtually all the entire area is saturated.
• Class 4 relates to specialty drying situations. Wet materials with very low permeance/porosity (eg. hardwood, plaster, brick, concrete, light-weight concrete and stone). Typically, there are deep pockets of saturation, which require very low specific humidity. These types of losses may require longer drying times and special methods.

We have the knowledge, experience and proper equipment to locate any hidden moisture lurking out of sight and clean up water damage of any size and get it done right the first time.

Moisture sensors, which are used to detect moisture in carpets, baseboards and walls. We have moisture meters that we use to test the actual moisture content of materials. The meters allow our technicians to accurately monitor the drying process. Our team also has thermohygrometers on hand to measure temperature and relative humidity, which ensures techs can calculate and create an environment that is most conducive to drying.